Door Removal And Temperature Control - Electrolux E32AF75JPS Use And Care Manual

Door Removal and Temperature Control

Door Removal
If door must be removed:
Doors are heavy. It is recommended to have two people to remove or replace the door assembly from
the cabinet.
• Unplug the unit or switch the breaker that supplies
power to the unit to the off position.
• Remove the plastic top hinge cover.
• Hold the door in place while removing the top
hinge from the cabinet.
• Remove the two 3/8" hex head bolts from the top
hinge with a 3/8" wrench or socket.
• Lift the door upwards and pull up and away from
the cabinet until free of the bottom hinge pin
mounted on the front of the cabinet.
• To replace the door, reverse the above procedures
and securely tighten all screws to prevent hinge
slippage.
Setting The Custom Set™ Electronic Control
COOL DOWN PERIOD
For safe food storage, allow four (4) hours for freezer to cool down completely. The freezer will run continuously
for the fi rst several hours.
Custom Set™ ELECTRONIC CONTROL
The Custom Set™ Electronic Control is located inside the freezer. Temperature is factory preset to provide
satisfactory food storage temperatures. However, the temperature control is adjustable to provide a range of
temperatures for your personal satisfaction.
To adjust the temperature setting, press the UP (+) key for warmer temperature and DOWN (-) key for colder
temperature on the control panel. Allow several hours for the temperature to stabilize between adjustments.
The freezer can be adjusted between -10°F (-23°C) and 10°F (-12°C). By pressing the TEMP MODE key, the
temperature display will toggle between °F to °C.
To turn the freezer OFF, press the UP (+) key until the warmest temperature setting of 10Fº (-12Cº) shows in the
display. Then press the UP (+) key three (3) times within three (3) seconds to turn the freezer OFF. The display
will then scroll "OFF" across the display. To turn the unit back ON, press the DOWN key three (3) times within
three (3) seconds. The control will then display "10Fº (-12Cº)" and may be adjusted to the desired temperature.
Hinge Cover
Hinge Bolts (2)
Hinge Plate
9