Electrolux E32AF75JPS Use And Care Manual page 8

8 Leveling
To Level The Freezer:
While unit is lying on its back for wood skid removal,
note the location of the four (4) leg levelers installed at
each corner. These leg levelers will be used to level
the freezer and to adjust the height. Use a carpenter's
level to level the freezer from front to back and side to
side.
Make sure to allow for the Trim and Leveling Kit if it is
to be installed with the unit.
Leveling Instructions For Matching Tall
Refrigerator / Tall Freezer Pair:
• Level door of fi rst unit using all four levelers and
slide unit into place. Recheck for levelness and
adjust if necessary.
• Measure distance from fl oor to bottom of door on
fi rst unit. Adjust and level second unit so door
height matches.
• Leg Level Adjustments:
• One full turn of all four leg levelers will raise door
5/32".
•
•
Leveling Door with Adjustable Hinge
Use the lower hinge adjustment to fi ne tune the door
height and for fi nal cabinet spacing. Use a 7/16 inch
socket or wrench to adjust the screw at the bottom of
the lower hinge.
Adjusting Doors For Matching Tall
Refrigerator / Tall Freezer Pair
The doors may also be adjusted side to side with the
slotted hinge for aligning the doors parallel to each
other. Loosen the two bolts with a 3/8" wrench and
one screw with a Phillips screwdriver. Shift the doors
until parallel, then retighten the screws securely. (See
illustration below.)
Lower Hinge Adjustment For Leveling The
Doors Of The Matching Tall Refrigerator /
Tall Freezer Pair
To level the doors using the adjustable lower hinge
(some models):
1. If the refrigerator door is lower than the freezer
Level Front to Back
& Side to Side
2. If the freezer door is lower than the refrigerator
Slide second unit into place leaving a minimum
gap of 3/16" between units for door swing
clearance.
This last step may require at least one extraction
of the second unit to properly align units in a
"built-in" application.
door, raise the refrigerator door by turning the
adjustment screw clockwise using a 7/16 inch
socket wrench. (See illustration.)
door, raise the freezer door by turning the
adjustment screw clockwise using a 7/16 inch
socket wrench. (See illustration.)