GAS GAS EC ROOKIE - 2005 Service Manual page 32

Installation of batteries
Fig.2
- To replace the batteries, remove the cover of the battery space by unscrewing the two screws at the
back of the multi-function.
- Substitute the old batteries with the new ones, maintaining the same polarity which is indicated
Fig.3
on the diagram.
- Finally, screw on the cover again. (Fig. 2)
- If the previous process has been carried out correctly, all the segments and legends of the screen
Fig.4
will appear momentarily. (Fig. 3). After a few seconds, the clock symbol will appear with a reading
of zeros (Fig. 4), disappearing after 10 seconds.
Instantaneous speed
On turning on the motor, the reading of Km/h. will appear automatically.
While the motor is in operation, the instantaneous speed reading will remain on the screen (Fig. 5).
On detaining the motor, the screen will remain lit up for about ten seconds with the indication of zero
Km/h. After this time, if the motor is not turned on again, the last function previously selected will
appear on the screen. The screen will turn off completely after one minute, if during this time the
Fig.5
power has not been turned on again or if a function has been selected.
While this function is visualised, it is not possible to select any other one.
Setting the time
Press the MODE key until the clock symbol appears. By pressing the START key, the minute digits
and the clock symbol will flash, indicating that it is in time set mode (Fig. 6).
By pressing lightly on the START key, the minutes indicator will be advanced.
On keeping the same key pressed, the advance will be automatic, being detained on letting go of the
key. On pressing the MODE key, the hour digits will flash, proceeding in the same way as above.
Once the correct values have been selected, press the MODE key to give said values. The digits will
Fig.6
stop flashing.
30
- -