Storage; Gas Gas Multifunction Instructions - GAS GAS EC - 2005 Service Manual

STORAGE

For extended storage of the motorcycle, you must do the following:
- Clean the motorcycle thoroughly.
- Start the engine for about 5 minutes to warm up the transmission oil and then
drain it (refer to the transmission section).
- Fill with new transmission oil.
- Empty the fuel tank (gasoline will deteriorate if left too long).
- Disconnect the battery.
- Lubricate the drive chain and all cables.
- Cover all unpainted metal surfaces with a coat of oil to prevent rust, do not
apply oil to the brakes and rubber parts.
- Cover the exhaust pipe with a plastic bag to prevent corrosion.
- Place the motorcycle in such a position so that the wheels do not touch the
ground (if this is not possible, place cardboards under the wheels).
- Cover the motorcycle to protect it from dust and dirt.
When starting off after an extended storage:
- Remove the plastic bag from the exhaust pipe.
- Tighten the spark plug.
- Fill the fuel tank.
- Check all points marked in the section "Daily Inspection Before Riding".
- General lubrication.
- Connect the battery.
GAS GAS MULTIFUNCTION INSTRUCTIONS (only EC & SM)
The multifunction display incorporates two buttons, one to change
the screen display (Mode) and the other to Reset certain functions.
Reset
Mode
Al conectar la pila aparece la pantalla de reloj/crono, pulsando Mode
cambiará sucesivamente de pantalla según el orden siguiente:
1. Clock/chrono.
2. Speed (Km or miles/hour according to program set).
3. Total distance (in km or miles). This counter has a memory even
if the battery is disconnected).
4. Trip distance (allows to reset to zero).
To set the time:
Time setting must be done with the clock on display and pressing
00:00
Clock / Chrono
(Tp change the screen display press the Mode button.)
117
EC / MC / SM 2005 - -
00:00
0
Speed