Table of Contents
Advertisement
WARNING: If the information in this manual is not followed exactly, a fire or explosion may result causing property
damage, personal injury or loss of life.
– Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.
– WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch.
• Immediately call your gas supplier. Follow the supplier's instructions.
• If you cannot reach your gas supplier, call the fire department.
– Installation and service must be performed by a qualified installer, service agency or the gas supplier.
0117WB036S
0117WB039E
OUTDOOR WOOD FURNACE
OWNER'S MANUAL
CLEANFIRE 700
CLEANFIRE 500
CLEANFIRE 300
SAVE THESE
INSTRUCTIONS
(p/n 9000752) - JUN 2020
Advertisement
Table of Contents
Related Manuals for Wood master CleanFire 300
Summarization of Contents
Foundation
Furnace Installation Dimensions
Provides dimensions for CleanFire 300, 500, and 700 models for foundation planning.
Access to Ports on Outdoor Furnace
CleanFire 700 Model – 3-Pump Configuration
Details the parts and configuration for a 3-pump system on the CleanFire 700 model.
CleanFire 300/500 Models – 1-Pump Configuration
Illustrates the parts and configuration for a 1-pump system for CleanFire 300/500 models.
CleanFire 300/500 Models – 2-Pump Configuration
Details the parts and configuration for a 2-pump system for CleanFire 300/500 models.
Furnace Installation - Connecting to Your Existing System
Typical Installation
Describes connecting the furnace to a water heater and forced air furnace system.
Remote Thermal Storage Installation
Explains connection to a remote thermal storage tank for heating systems.
Outdoor Wood Furnace Best Burn Practices
Chimney Recommendations
Guidelines for chimney height and placement in populated areas.
Chimney Installation
Step-by-step instructions for assembling and installing chimney sections.
Water Quality and Maintenance
Adding Antifreeze to Outdoor Furnace System
Instructions for adding nontoxic propylene glycol and MolyArmor 350 for freeze protection.
Initial Water Treatment, Fill and Testing
Steps for initial water treatment, filling the system, and basic testing procedures.
Water Samples
Water Sample Kit
Information on obtaining and using the water sample kit for testing.
When to Submit Water Sample
Details the schedule for submitting initial and annual water samples for warranty.
System Maintenance
Water Test Kits and Test Results
Guidance on using water test kits and recording pH and Moly levels.
Operating Instructions
Firestar Combustion Controller
Information on the operation of the FireStar combustion controller.
How the CleanFire Works
Explanation of the CleanFire's efficient combustion design and principles.
Maintenance Schedule
Preventive Maintenance Schedule
A table outlining regular maintenance tasks and their recommended service intervals.
Control Locations
Routine Maintenance
Guidance on essential routine inspections and maintenance for furnace longevity.
Maintenance Sections
Section 1 - Water Level
Procedure for checking the water level using the sight gauge.
Section 2 - Vent Cap
Instructions for inspecting the vent cap for obstructions and proper fit.
Section 3 - Ash
Refers to the 'Adding Wood' section for ash removal procedures.
Section 4 - Firebox Door Seal and Bushings
Details on inspecting, adjusting, and replacing the firebox door seal and bushings.
Section 5 - Chimney Tee and Chimney
Procedure for inspecting and cleaning the chimney tee and sections.
Section 6 - Heat Exchangers
Instructions for inspecting and cleaning heat exchangers for optimal performance.
Section 7 - Reaction Chamber
Steps for cleaning ash and deposits from the reaction chamber.
Section 8 - Firebox
Procedures for cleaning ash, deposits, and checking for corrosion in the firebox.
Section 9 - Combustion Air Tubes
Maintenance steps for cleaning or removing combustion air tubes.
Section 10 - Combustion Air Fan
Procedures for cleaning and oiling the combustion air fan.
Serviceable Items
Firebox Door Hinge / Latch Bearing Adjustment
Instructions for adjusting firebox door hinges and latch for proper sealing.
Firebox Door Seal
Procedure for replacing the firebox door seal to ensure an airtight seal.
Troubleshooting
General Troubleshooting Information
General advice for resolving operational issues by reviewing specific sections.
Troubleshooting Other Situations
A. Outdoor Furnace Is Not Operating Correctly
Troubleshooting steps for common issues when the furnace is not operating correctly.
B. Fire Goes Out or Keeps Going Out
Guidance for diagnosing and resolving issues where the fire extinguishes unexpectedly.
C. Building Is Losing Temperature
Troubleshooting steps for diagnosing heat loss issues in the building.
Need help?
Do you have a question about the CleanFire 300 and is the answer not in the manual?
Questions and answers