Sherwood RX-772 Operating Instructions Manual page 14

Listening in the desired tone mode
.
1
Select the desired tone mode.
.
2
Adjust the tone (treble and bass) as desired.
Adjusting the modes as desired
�You can adjust the speaker, the tone and the balance modes as desired.
.
1
Select the desired mode.
.
2
Adjust the selected mode as desired.
�Each time this button is pressed, the tone mode
changes as follows :
OFF : To listen to a program source without the
tone effect.
�
ON : To listen with the tone effect you adjusted.
When adjusting the treble
�When you select the tone on mode, you can listen
to a program source with the tone effect you
adjusted.
�When pressing the TREBLE UP/DOWN(
BASS UP/DOWN(
∧ ∧ / / ∨ ∨
can be adjusted within the range of -10 ~ +10.
�Notes:
�Extreme settings at high volume may damage your
speakers.
�In general, the bass and treble levels are adjusted
to 0.
�Each time this button is pressed, the mode is
displayed for several seconds and changes as
follows :
� SPEAKER (�TONE : ON�BASS�TREBLE) or
BALANCE ( � TONE : OFF) �
�Each time the SELECT konb is rotated, you can
adjust the selected mode as follows.
�Note :
�The mode display disappears, perform the above
step 1 again.
13
) or
∧ ∧ / / ∨ ∨
) buttons, the tone level