Installing Logs - Desa Comfort Glow CGB3924NRA Owner's Operation And Installation Manual

INSTALLATION
Continued
INSTALLING WIRELESS
REMOTE CONTROL
ACCESSORY
Two 9-volt alkaline batteries (not included)
are required to operate this heater with the
wireless hand held remote control set. One
battery must be installed in the receiver and
one in the hand-held remote control unit.
Note: Only use alkaline batteries.
Installing 9-Volt Battery in
Receiver
1. Locate back of receiver under front
burner of heater.
2. Locate the battery clip mounted on the
back of the receiver.
3. Slide a 9-volt battery through the clip.
4. Attach the terminal wires to the battery.
Receiver
Battery Clip
9-Volt Battery
Figure 19 - Installing Receiver on the
Back of the Base
Installing 9-Volt Battery (Not
Included) in Hand-Held Remote
Control Unit
1. Remove battery cover on back of re-
mote control unit.
2. Attach terminal wires to the battery.
Place battery into the battery housing.
3. Replace battery cover onto remote con-
trol unit.
105677
Terminal
Wires
9-Volt
Battery
Figure 20 - Installing Battery in Hand-
Held Remote Control Unit

INSTALLING LOGS

(CGD3924NRA)
WARNING: Failure to position
the parts in accordance with these
diagrams or failure to use only
parts specifically approved with
this heater may result in property
damage or personal injury.
CAUTION: After installation
and periodically thereafter, check
to ensure that no flame comes in
Terminal
contact with any log. With the
Wires
heater set to HIGH, check to see
if flames contact any log. If so,
reposition logs according to the
log installation instructions in this
manual. Flames contacting logs
will create soot.
Each log is marked with a number. These
numbers will help you identify the log when
installing. It is very important to install these
logs exactly as instructed. Do not modify
logs. Only use logs supplied with heater.
1. Locate pegs on the bottom of back log (#1).
Slide these pegs into the holes in the grate
base behind the burner (see Figure 21).
2. Place the base of the middle log (#2) in
the U-shaped slots of the grate base in
front of the back log. The cutout on the
right of the middle log should fit over the
burner (see Figure 22). Make sure the
front of the middle log is resting on the
tabs of the grate base and the cutout area
is centered over the burner "U" bend.
3. Locate the recesses on the back of the
front log (#3). Fit these recesses between
the posts of the grate base (see Figure 23).
OWNER'S MANUAL
Battery Cover
Remote
Control
Unit
Battery Housing
13
Peg
Hole in
Grate Base
Figure 21 - Installing Back Log (#1)
Middle Log (#2)
Tab
Burner
Figure 22 - Installing Middle Log (#2)
Front Log (#3)
Post
Figure 23 - Installing Front Log (#3)
Back Log (#1)
Burner
Cutout
"U" Bend
U-Shaped
Slot
Recess
Post
Continued