Related Manuals for REMKO HTL 170
Summarization of Contents
Unit Description
Operating Sequence
Describes the automatic heating and ventilating modes of the unit.
Locations of Use
Lists commercial applications for mobile, directly fired fan-assisted heaters.
Installation Instructions
Installation Outside
Guidelines for operating units outdoors and ensuring weather protection.
Installation in Enclosed Areas
Conditions for operating units in enclosed spaces with exhaust gas routing.
Room Heating Setup
How to use units for room heating with a thermostat.
Safety Distances
Specifies the required safe operating and maintenance distances around the unit.
Safety Equipment
Safety Temperature Limiter (STB)
Explains the function and manual resetting of the safety temperature limiter.
Regulating Device Details
Details temperature sensors, probes, and controller functions.
Temperature Controller (TR)
Describes the function of the temperature controller for fan switching.
Temperature Monitor (TW)
Explains how the temperature monitor limits unit temperature via the burner.
Automatic Burner Safety
Explains how the automatic burner switches off due to flame monitoring or fuel issues.
Exhaust Ducting
Notes for BlmSchV Implementation
Information on approvals and monitoring requirements for the 1st. BlmSchV.
Before Commissioning
Air Distribution Setup
Explains the fan design and air distribution via hoses or ducting.
Suction Air Modes
Describes fresh air, mixed air, and circulated air operating modes.
Commissioning
Connecting Electrical Power Supply
Step-by-step guide to connecting the unit to the electrical power supply.
Control Panel Overview
Identifies and explains the components of the unit's control panel.
Heating Without Room Thermostat
How to operate the unit in permanent mode without a room thermostat.
Shutdown Procedure
Heating with Room Thermostat
Instructions for operating the unit automatically based on room temperature.
Ventilate Mode Operation
How to use the unit for air recirculation or ventilation purposes.
Care and Maintenance
General Cleaning Tasks
Outlines general cleaning requirements for the unit and its components.
Cleaning the Heat Exchanger
Detailed steps for cleaning the heat exchanger and related parts.
Cleaning the Combustion Chamber
Burner Flange Installation
Steps for installing the burner flange onto the unit housing.
Additional Maintenance Notes
Important considerations for unit maintenance, emphasizing specialist involvement.
Troubleshooting
Unit Does Not Start Troubleshooting
Step-by-step checks for when the unit fails to start.
Burner and Power Supply Issues
Troubleshooting steps related to the burner and electrical supply.
Supply Air Fan Failure
Checks to perform when the supply air fan fails to operate.
Commissioning the Forced-Air Oil Burner
Preparatory Tasks
Initial steps and precautions before commissioning the oil burner.
Burner Adjustment and Installation
Guide to adjusting ignition, baffle plate, nozzles, and mounting baseplate.
Need help?
Do you have a question about the HTL 170 and is the answer not in the manual?
Questions and answers