ASCOM Ascotel Office 155pro User Manual page 10

Safety and Liability
Intended Purpose
This telephone is designed exclusively for making and receiving phone calls on the appropriate system.
The handset can also be operated on foreign language systems in GAP mode.
Dealing with batteries
Please observe the following rules and regulations when dealing with batteries
General rules when dealing with batteries:
• Never tamper with or dismantle batteries
• Never immerse the batteries in water or throw it into a fire.
• Do not expose the batteries to high temperatures.
When putting your mobile phone into operation:
• Only use the Ni-MH battery pack supplied by the manufacturer.
• Take note of the instructions in the "Installation" chapter and follow the procedure described there.
• It takes two to three charging cycles for the batteries to reach their fully charged state.
• Only use the charging bay supplied by the manufacturer or the optional original plug-in power adapter
to recharging the batteries; otherwise the batteries may be damaged.
• For the charging bay only use the plug-in power adapter supplied by the manufacturer.
When operating your mobile phone:
• It is normal for the batteries to become warm when charging.
• Discharge the batteries from time to time to prolong their service life. To do so do not place the phone
back into the charging bay until the batteries are completely or almost completely discharged.
To replace the batteries:
• Switch off the phone before removing the batteries.
• Only use the original battery packs and charging units approved by the manufacturer. To do so,
contact your supplier or servicing agent.
To store the phone or the batteries:
• If you do not intend to use the phone for some time, switch off the phone and take out the battery
pack.
• Store the batteries at room temperature. Above-average temperatures tend to reduce the service life
of batteries.
To dispose of the battery packs:
• Do not throw away the batteries with your domestic waste. Take the batteries to an appropriate
collection point for recycling or send it back to your supplier or servicing agent.
Exclusion of Liability
This product is manufactured in accordance with ISO 9001 quality criteria.
This product and the user information supplied with it have been produced with the utmost care.
The product's functions have been tested and approved after comprehensive conformity tests.
Nonetheless errors cannot be entirely excluded. The warranty is limited to the replacement of defective
hardware.
The manufacturers shall not be liable for any direct or indirect damage that may be caused by incorrect
handling, improper use, or any other faulty behaviour on the part of a product. Potential hazards are
mentioned in the relevant places in the User Guides. Liability for loss of profit shall be excluded in any case.
10