Table of Contents
Advertisement
You will need a 9 pin male-to-female, fully wired, pin-to-pin RS232 cable
Note: this lead should be pin-to-pin – not the null modem type.
To load the latest presets into your DX1.5
1.
Connect the 9-pin male to 9-pin female DEE type serial lead from your computer to the
external socket on the rear of the unit.
2.
On the DX1.5 use the blue Menu, Back,
menu and then into External Interface.
3.
Once entered, setup as follows:
Serial Speed: 38400
Press
Enter
to confirm
4.
Run the programme MartinFlashLoader.exe.
5.
Set the Serial Port Speed to 38400.
The bottom right hand window should indicate Good Response.
If the Serial Speed number is not set to 38400 to match the DX1.5 speed, the software lower
right window may indicate No Response.
All material © 2009. Martin Audio Ltd. Subject to change without notice.
Next
and
Enter
keys to go into the Interface Sub-
Advertisement
Table of Contents
