Table of Contents
Advertisement
Free Assign Routing
If none of the preset configurations are appropriate to the required system setup, it is possible
to manually select the routing of the crossover. This is achieved through the Crossover
Menu > Design a Crossover.
Pressing ENTER will start the crossover design wizard, with the first option being to choose
the routing.
The display will show, for instance
Design a Crossover ->
Routing = 2 X 3 WAY
or whatever the current configuration is set to.
Press BACK until the display shows
Design a Crossover ->
Routing = Free Assign
And then press ENTER. The EDIT key will illuminate for output 1, as will any relevant input
EDIT keys, showing which inputs are feeding output 1. The display will also detail the current
combination of inputs feeding this output. To change the routing for any output, press its
EDIT key, and then choose the required input channel combination by just pressing the input
EDIT keys as appropriate. The input combinations can also be stepped through in turn by
pressing NEXT, or BACK.
To complete the procedure, press ENTER.
The screen will show:
Design a Crossover ->
Clear Settings : No *
Press ENTER again.
The wizard will continue, and if the routing has been changed, all outputs will be muted on
exit.
All material © 2009. Martin Audio Ltd. Subject to change without notice.
Advertisement
Table of Contents
