Playing Cds - Arcam FMJ MS250 Manual

Playing CDs

To play a CD, press
with the label facing uppermost. Press
tray.
After a few seconds, the track names appear on the display.
To select particular tracks, use the
on the front panel) to move down and up the tracklist.
toggles a track from selected (red square before the track number) indicating
OK
that the track is to be played; to unselected (open square before the track number),
indicating that the track is to be skipped.
The MS250 plays all selected tracks from the highlighted track to the end of the
selection. If you have set the 'Repeat' item to 'Repeat: on', playing starts again from the first selected
track. The default setting is 'Repeat: off'. You can also instruct the MS250 to play tracks in a random
order from the CD by changing the 'Shuffle' menu item to 'Shuffle: on'.
See pages 9 and 10 ('Front panel controls' and 'Using the CR-425 remote control') for how to pause,
stop, skip tracks, etc.
To play the whole CD, simply press
information, the display on the TV/monitor (and a version of the information on the front panel)
appears:
MS250
12
(or on the remote control) to open the CD tray. Place the CD in the tray
LOAD OPEN
again (or
LOAD
C B
and keys on the remote (or
on the remote or front panel. After a delay to collect the
PLAY
again on the remote control) to close the
OPEN
6 5
and keys
NOTE
If the MS250 is not connected to the
Internet, or the database does not
contain details for the CD inserted,
tracks will be listed by number only.
NOTE
The front panel display indicates
the volume level (0-100). This is
the output level of the signal fed
to your amplifier. If you can access
your amplifier's volume control, you
should set the MS250 volume control
to maximum (100) and adjust the
volume level on the amplifier to your
requirements.