Central Hydraulics 99887 Set Up And Operating Instructions Manual page 8

directly below the motorcycle manu-
facturer's recommended lifting points.
be shut off prior to lifting the ve-
hicle.
5. Slowly pump the Handle (18) of the
Motorcycle Lift until the Arm Lift (13)
slightly contacts the vehicle's lifting
points. (See Figure H.)
6. Use the two Straps with Hooks (25)
to secure the motorcycle to the Arm
Lift (13). To do so, connect the two
Hooks to a suitable location (i.e., the
frame) on the motorcycle. Depress
the two Strap Release Levers (24)
on the Arm Lift. Pull each Strap to
tighten and secure the vehicle to the
Arm Lift. Then release pressure on
the two Strap Release Levers. (See
Figure H.)
7. Check to make sure the motorcycle
is firmly secured to the Arm Lift (13).
(See Figure H.)
8. With the Release Valve (23X) closed,
slowly pump the Handle (18) of the
Motorcycle Lift to raise the vehicle.
Check to make sure the load is bal-
anced. If not, lower the Motorcycle
Lift completely. Reposition and se-
cure the load. Then raise again.
(See Figure H.)
9. Raise the motorcycle to the desired
working height (from 2-1/2" to 30").
Then insert the Position Pin (17) into
the Post (19) to lock the Arm Lift (13)
in place. (See Figure j.)
place with the Position Pin (17)
SKU 99887
The engine of the
motorcycle must
aLWaYS lock the
arm Lift (13) in
For technical questions, please call 1-800-444-3353.
once the motorcycle has been
raised. (See Figure j.)
10. Once the repair work on the motor-
cycle is completed, remove all used
parts, tools, equipment, etc. from
under the Motorcycle Lift.
11. Remove the Position Pin (17) from
the Post (19). (See Figure j.)
12. Slowly turn the Release Valve (23X)
counterclockwise to fully lower the
two Arm Lifts (13) to the floor surface.
(See Figure G.)
13. Once fully lowered, depress the Strap
Release Lever (24) on each Arm Lift.
Pull each Strap to loosen and remove
the two Hooks securing the vehicle to
the Arm Lifts. Then release pressure
on the two Strap Release Levers.
(See Figure H.)
14. Pull the Motorcycle Lift backwards
until the two Arm Lifts (13) are com-
pletely out from under the motorcycle.
15. Transport the Motorcycle Lift to a
clean, dry, safe storage location out
of reach of children and other unau-
thorized persons.
FIGuRE j
POSITION PIN
(17)
Page 8