Table of Contents
Advertisement
Operation
Single Acting and Double Acting Bead Spray Guns for
™
RoadLazer
RoadPak
- For the application of road marking reflective materials -
Model: 238338 - Single Acting Bead Spray Gun
Model: 24G979 - Double Acting Bead Spray Gun
200 psi (1.38 MPa, 13.8 bar) Maximum Working Pressure
Important Safety Instructions
Read all warnings and instructions in this
manual. Save these instructions.
Single Acting Bead Spray Gun
™
Line Striping System
- For professional use only -
Double Acting Bead Spray Gun
308612K
EN
T5
II 2 G
Advertisement
Table of Contents
Related Manuals for Graco 24G979
Summarization of Contents
Operation
Important Safety Instructions
Read all warnings and instructions in this manual. Save these instructions.
Warnings
EQUIPMENT MISUSE HAZARD
Misuse can cause death or serious injury. Follow safety guidelines for operation and maintenance.
PERSONAL PROTECTIVE EQUIPMENT
Wear appropriate protective gear for operation and servicing to prevent serious injury.
CALIFORNIA PROPOSITION 65
Engine exhaust may cause cancer, birth defects or other reproductive harm.
Installation
Mount Valve
Mount the valve on a 0.50 in. diameter rod on a mounting fixture or dispensing machine.
Connect the Air Lines
Clean and blow out lines before connecting. Install an air filter for the air supply line.
Connect Material Line
Connect the material line to the system.
Grounding
Proper grounding is essential to maintaining a safe system to reduce static sparking.
Operation Procedures
Pressure Relief Procedure
Steps to safely relieve pressure from the bead tank and dispensing valve.
Application Data
Reference for Nozzle Size Selection and Bead Delivery Tables.
Nozzle Size Selection
Guide to selecting the correct nozzle size for travel speed and bead coverage.
Maintenance
Clean Dispensing Valve and System Daily
Clean valve exterior by wiping with a solvent-dampened cloth. Do not immerse.
Oil Dispensing Valve Daily
Lubricate inside the protection tube before each use to prevent fluid buildup.
Service
Needle, Seat and Packings
Procedure to clean or replace the needle, seat, or packings.
Air Piston, Spring and Seals
Procedure to clean and inspect air piston, spring, and seals.
Graco Standard Warranty
Graco Information
Information on Graco products, ordering, and contact details.
Need help?
Do you have a question about the 24G979 and is the answer not in the manual?
Questions and answers