Serial Terminal - Panasonic AE3000U - LCD Projector - HD 1080p Operating Instructions Manual

Serial terminal

The serial connector which is on the connector panel of the projector conforms to the RS-232C interface
specification, so that the projector can be controlled by a personal computer which is connected to this connecter.
Connection
NOTE:
• You must use only an RS-232C Serial Interface Cable with a ferrite core, type ET-ADSER.
Pin assignments and signal names
Cable specifications
(When connected to a personal computer)
Basic format
STX Command
Start byte
3 bytes
(02h)
The projector can not receive any command for 10 seconds after the lamp is switched on. Wait 10 seconds
before sending the command.
If sending multiple commands, check that a response has been received from the projector for one
command before sending the next command.
When a command which does not require parameters to be sent, the colon (:) is not required.
If an incorrect command is sent from the personal computer, the ER401 command will be sent from the
projector to the personal computer.
Pin No.
A
B
C
D
E
F
G
H
I
Projector
: Parameter ETX
1 byte
1 byte -
(03h)
4 bytes
D-sub 9 pin (male)
Serial terminal (female)
Signal name
TXD
RXD
GND
RTS
CTS
NC
NC
NC
NC
The data streaming from the computer will
start with STX, and proceed to Command,
Parameter and end with ETX. You can
End
add the required parameter.
Technical Information
Computer
Contents
NC
Transmitted data
Received data
NC
Earth
NC
Connected internally
NC
NC
PC (DTE)
NC
NC
NC
E
NGLISH - 51