Xtant BLM-1 Owner's Manual

INSTALLING THE BLM-1
STEP 1: Locating the Connector
A. Remove the BLM-1 from the packaging and
inspect the circuit board.
B. Locate the right angle header connector sol-
dered on the circuit board next to the Xtant logo.
See illustrations 2
C. Tip the BLM-1 on end and view the right angle
header connector. Notice that one of the openings
on the header connector is blocked by white filler
material. The BLM-1's mounting system utilizes
this blocked receptacle as the "key" to insure
proper positioning when installing the BLM-1
onto the amplifier's mounting port. See illustra-
tion 1.
RIGHT ANGLE
HEADER CONNECTOR
CIRCUIT BOARD
INSTALLING THE BLM-1
STEP 2: Adjusting the BLM-1
A. It is easier to make your initial input sensitivi-
ty adjustment to the BLM-1 prior to installing the
module in the amplifier. Please note that the
BLM-1 bypasses the input adjustment on your
Xtant amplifier. Once installed, all input sensitiv-
ity adjustments must be made on the BLM-1.
B. Each of the five jumper positions (-20, -10, 0,
+10, +20) will affect the level of the input signal.
Refer to the chart below to determine the jumper
position which best suits your system. See illus-
tration 2
Setting
–20 dB
–10 dB
0 dB
+10 dB
+20 dB
H O W T O U S E T H E I N P U T M U L T I P L I E R
Head Unit's Output Voltage
" "
LOCATING KEY
Resulting Input Voltage
C. Locate the input gain jumper which is preset to
the +10 position. To change the input sensitivity,
simply remove the jumper and place it one of the
other four positions (-20, -10, 0, +20 dB).
illustration 1
Input Multiplier Result
x .10 reduces signal
x .3 reduces signal
x 1 no change
x 3 boost signal
x 10 boost signal
500 mV
+10 dB Multiplier x 3
1.5 Volts
INSTALLING THE BLM-1
STEP 3: Plugging-in the BLM-1
INPUT GAIN JUMPER
–20 –10 0 +10 +20
RIGHT ANGLE
xtant
HEADER CONNECTOR
BLM-1
MOUNTING PORT
A. Turn-off amplifier. Remove amplifier cover and
locate the Balanced Line Port.
B. Remove the two header jumpers and locate the
missing pin ("key") on the port.
C. Align the blocked receptacle with the missing pin
and press the BLM-1 onto the mounting port.
D. Turn amp on and audition input signal level. If
further adjustment is necessary, turn amp off and
reposition the input gain jumper to achieve the
desired input signal level.
illustration 2