Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Friedrich ZoneAire PZE15K
Summarization of Contents
General Instructions
Installation Importance
Emphasizes following installation instructions closely for trouble-free service.
General Specifications
Unit Components and Dimensions
Details typical unit components and their physical measurements.
Model Identification Guide
Explains the coding system for PTAC/PTHP model numbers.
Installation Checklist
Pre-Installation Checks
Lists essential checks for components and structural support before installation.
PTAC Installation Recommendations
Minimum Clearance Guidelines
Provides minimum spacing requirements for optimal unit performance and longevity.
Wall Sleeve Installation (PDXWSA)
Standard Wall Sleeve Setup
Instructions for installing the standard wall sleeve for walls under 13 1/4" deep.
Deep Wall Sleeve Considerations
Refers to instructions for installations in walls deeper than 13 1/4".
Alternate Wall Installations
Panel and Frame Wall Mounting
Illustrates installation methods for panel, frame, and brick veneer walls.
Curtain and Block Wall Mounting
Shows installation on curtain walls and block/brick veneer structures.
Lintel Installation
Masonry Wall Support
Details lintel requirements for wall sleeves in concrete or masonry walls.
Deep Wall Sleeve Installation (PDXWSEXT)
Extended Sleeve Requirements
Instructions for installing deep wall sleeves or extensions for walls over 13 1/4" thick.
Drain Kit Installation (PXDR10)
Internal Drain Setup
Procedures for installing the PXDR10 drain kit for internal condensate drainage.
External Drain Installation
Drain Tube and Cover Plate
Steps for connecting drain tubes and cover plates for external condensate removal.
Standard Grille Installation (PXGA)
Grille Mounting Procedure
Instructions for attaching the standard PXGA grille to the wall sleeve.
Electrical Ratings and Power Cords
Electrical Specifications
Details voltage, amperage, heater size, and receptacle types for units.
LCDI Power Cord Testing
Guide on how to test the Leakage Current Detection Interrupter power cord.
265 Volt Electrical Wiring
Non-LCDI Power Cord Installation
Instructions for hardwiring 265V units and preparing power cords.
Chassis Installation Preparation
Sleeve Component Removal
Steps to remove internal supports before chassis installation.
Front Cover Handling
Procedures for removing and handling the unit's front cover.
Chassis Installation
Securing the Unit
Steps for lifting and securing the chassis within the wall sleeve.
Reinstalling the Front Panel
Instructions for reattaching the front panel after chassis installation.
Product Features
Digital Temperature Readout
Displays and controls room temperature digitally for precise comfort.
Remote Thermostat Operation
Allows unit control via a standard wall-mounted thermostat.
System Configuration
Fresh Air Vent Control
Explains operation of the vent control for circulating indoor or outdoor air.
Adjusting Airflow Direction
Guides on how to change the direction of the air discharge.
Digital Control User Input Configuration
Dip Switch Settings
Details the function and settings of the unit's internal DIP switches.
Digital Control Operation
Cooling and Heating Modes
Explains how to operate the unit in cooling, heating, and heat pump modes.
Emergency Heat Operation
Describes the unit's fallback to electric heat during compressor failure.
Remote Control Thermostat Installation
Thermostat Mounting Precautions
Lists locations to avoid when mounting a thermostat for accurate readings.
Low Voltage Control Connections
Thermostat Wiring Guide
Details terminal connections for wall thermostats and unit compatibility.
Front Desk Control Terminal
Energy Management Control Input
Explains how to connect an external switch for remote unit disabling.
Final Inspection & Start-up Checklist
Pre-Operation Inspection Points
Lists final checks for components, clearances, and compliance before operation.
Routine Maintenance Procedures
Key Maintenance Tasks
Covers cleaning of air filters, coils, chassis, and wall sleeves.
Basic Troubleshooting Guide
Start Failure Issues
Addresses common reasons for unit failure to start and their solutions.
Fan Operation Problems
Covers issues related to indoor/outdoor fan functionality and speed.
Cooling and Heating Performance
Solutions for problems with cooling, heating, noise, and smells.
Product Accessories
New Construction Accessories
Lists available accessories for new installations, including sleeves and grilles.
Drain and Conduit Kits
Details essential kits for condensate removal and hardwiring.
Limited Warranty Information
First Year Limited Warranty
Covers defects in material or workmanship for the first 12 months.
Second to Fifth Year Limited Warranty
Covers the sealed refrigeration system for the subsequent 48 months.
Need help?
Do you have a question about the ZoneAire PZE15K and is the answer not in the manual?
Questions and answers