McAfee VIRUSSCAN 5.1 Getting Started Manual page 37

Figure 5-1. VirusScan control panel - Components page
4. Select the Load VShield on startup checkbox at the top of the
Components property page.
5. Click OK to close the control panel.
Enabling the VShield scanner and its modules
Once you have all VShield components installed, you can use any of four
methods to enable them, in various combinations. Three methods appear here.
See the VirusScan User's Guide to learn about the fourth.
Š NOTE: Enabling a module means activating it and loading it into your
computer's memory for use. The VShield scanner can start and remain
active in memory even with none of its modules enabled.
Method 1: Use the VShield shortcut menu
Follow these steps:
1. Right-click the VShield icon
shortcut menu.
2. Point to Quick Enable.
3. Choose one of the module names shown without a check mark. Module
names that have a check mark beside them are active. Those without a
check mark are inactive. If you use this method to enable a module, it
remains enabled until you restart your VirusScan software or your
computer. At that point, its state will depend on whether you have
enabled or disabled the module in the VirusScan Properties dialog box.
Using the VShield Scanner
in the Windows system tray to display its
Getting Started Guide 37