Connections; Connecting Audio Components; Using The Remote Control Unit - Denon AVR-1604 Operating Instructions Manual

8 CONNECTIONS

• Do not plug in the power cord until all connections have been
completed.
• Be sure to connect the left and right channels properly (left with
left, right with right).
• Insert the plugs securely. Incomplete connections will result in
the generation of noise.
• Use the AC OUTLETS for audio equipment only. Do not
use them for hair driers, etc.
Connecting the audio components
Decoders with 6-channel
analog outputs, etc.
LINE OUT
LINE IN
LINE OUT
Tape deck or CD recorder
R L R L
R L R L
INPUT OUTPUT
Connecting a tape deck
Connections for recording:
Connect the tape deck's recording input jacks (LINE IN or
REC) to this unit's tape recording (OUT) jacks using pin plug
cords.
Connections for playback:
Connect the tape deck's playback output jacks (LINE OUT or
PB) to this unit's tape playback (IN) jacks using pin plug cords.
CD recorder, MD recorder or other component
equipped with digital output jacks.
B
OUTPUT
DIGITAL jacks
Use these for connections to audio equipment with digital output.
Refer to Page 25 for instructions on setting this terminal.
• Use 75 /ohms cable pin cords (sold separately) for coaxial
connections.
• Use optical cables (sold separately) for optical connections.
OUTPUT
R L
R L
LINE OUT
R L
R L R L
• When a sold separately room-to-room remote control unit
Subwoofer jack
Connect the internal amplifier's subwoofer to the subwoofer
OPTICAL
terminal. (Refer to page 14.)
INPUT
AC OUTLETS
• SWITCHED
The power to these outlets is turned on and off in conjunction with the POWER switch
on the main unit, and when the power is switched between on and standby from the
remote control unit.
No power is supplied from these outlets when this unit's power is at standby. Never
connect equipment whose total capacity is above 120 W (1 A.)
NOTE:
Only use the AC OUTLETS for audio equipment. Never use them for hair driers, TVs or
other electrical appliances.
• Note that binding pin plug cords together with power cords or
placing them near a power transformer will result in generating
hum or other noise.
• Noise or humming may be generated if a connected audio
equipment is used independently without turning the power
of this unit on. If this happens, turn on the power of the this
unit.
CD player
DIGITAL AUDIO DIGITAL AUDIO
Connecting a CD player
Connect the CD player's analog output jacks
(ANALOG OUTPUT) to this unit's CD jacks using
pin plug cords.
Extension jacks for future use.
AUX OUT
Another room
RC-617 (Sold Separately)
Infrared sensor
+ +
OUTPUT INPUT
(DENON RC-616, 617 or 618) is wired and connected between
the MAIN ROOM and ANOTHER ROOM, the remote-
controllable devices in the main room can be controlled from
ANOTHER ROOM using the remote control unit.
Connecting the AC OUTLETS
(total capacity – 120 W (1 A.))
AC CORD
AC 120V, 60Hz
RC-616
(Sold Separately)
Infrared retransmitter
ENGLISH
9