Dell 1133 Mono Laser User Manual page 7

life, which indicates the average capacity
of print-outs and is designed pursuant to
ISO/IEC 19752 (See
The number of pages may be affected by
operating environment, printing interval,
media type, and media size. Some
amount of toner may remain in the
cartridge even when End of life
Replace new cart appears and the
printer stops printing.
Error [error A systematic error has occurred
number]
Turn off
then on
Install The toner cartridge is installed improperly,
Toner or not installed.
Load There is no corresponding paper in the
[media size] corresponding tray.
in
[tray
number]
Not The toner cartridge is not suitable for your
Compatible machine.
toner
cartridge
Output bin The output tray is full. Or the sensor is not
Full facing down.
Remove
paper
Paper There is no paper in the indicated tray.
Empty
in [tray
number]
Pulled Out The indicated tray cassette is not inserted,
or not properly closed.
[tray
number]
Cassette
Paper Jam Paper has jammed in the manual tray area.
in MP Tray
Paper Jam Paper has jammed in the tray1 area.
in Tray 1
Paper Jam Paper has jammed inside the machine.
inside
machine
Paper Jam Special print media has jammed in the paper
exit area.
in exit area
Prepare Small amount of toner is left in the indicated
new cartridge. The estimated cartridge life of
cartridge toner is close.
Remove The machine cannot detect a toner
seal tape cartridge.
&Install
Toner
Replace The toner cartridge has almost reached its
Toner estimated cartridge life.
Available supplies).
Reboot the power and try the printing job again. If
the problem persists, call for service.
Reinstall the toner cartridge two or three times to
confirm it is seated properly. If the problem persists,
the toner cartridge is not being detected. Contact the
service representatives.
Load corresponding paper in the corresponding tray
(See
Install the corresponding toner cartridge with a Dell-
genuine cartridge (See
Remove papers from the output tray, the machine
resumes printing. Or make sure the sensor is facing
down. If the problem persists, call for service.
Load paper in the tray (See
tray).
To close the tray, lower the rear edge, align it with
the slot, and slide it into the printer.
Clear the jam (See
Clear the jam (See
Clear the jam (See
Clear the jam.
Prepare a new cartridge for a replacement. You may
temporarily increase the printing quality by
redistributing the toner (See
Remove the sealing tape from the toner cartridge.
Refer to Quick Install Guide.
You can choose between Stop or Continue as shown
on the control panel. If you select Stop, the printer
stops printing and you cannot print any more without
changing the cartridge. If you select Continue, the
printer keeps printing but the printing quality cannot
Loading paper in the tray).
Replacing the toner
In the manual
In tray 1).
Inside the
See In exit area.
See In the manual tray)
cartridge).
Loading paper in the
tray).
machine).
Redistributing toner).