Setting Up The System - Denon AVR-985 Operating Instructions Manual

7 SETTING UP THE SYSTEM

• Once all connections with other AV components have been completed as described in "CONNECTIONS" (see pages 6 to 14), make the various
settings described below on the monitor screen using the AVR-2805/985's on-screen display function.
These settings are required to set up the listening room's AV system centered around the AVR-2805/985.
Use the following buttons to set up the system
• Use the following buttons to set up the system.
1
Check that the remote control unit set to AMP mode.(TAPE, CDR/MD, CD)
2
• System setup items and default values (set upon shipment from the factory)
1. Auto Setup/Room EQ
Auto Setup/Room EQ
Power Amp
1
Auto Setup
Assignment
Manual EQ This parameter is for optimizing the Room EQ with which the audio
2
Setup signals are produced from the speakers.
Room EQ
3
Set the Room EQ setting with All or Assign for each surround mode.
Setup
Direct Mode Set the ON/OFF setting of Room EQ, in the case of the surround
4
Setup mode is in Direct or Pure Direct.
Set this to switch the Mic Input jack for use for Mic or V.Aux L-
5
Mic Input Select
channel input jack.
2. Speaker Setup
Input the combination of speakers in your system and their
Speaker corresponding sizes (SMALL for regular speakers, LARGE for full-
1
Configuration size, full-range) to automatically set the composition of the signals
output from the speakers and the frequency response.
This parameter is for optimizing the timing with which the audio
2
Delay Time signals are produced from the speakers and subwoofer according to
the listening position.
This adjusts the volume of the signals output from the speakers and
Channel
3
subwoofer for the different channels in order to obtain optimum
Level
effects.
Crossover Set the frequency (Hz) below which the bass so of the various
4
Frequency speaker is to be output from the subwoofer.
5
Subwoofer Mode This selects the subwoofer speaker for playing deep bass signals.
18
Set this to switch the surround back channel's
power amplifier for use for zone2.
Speaker Setup
SYSTEM SETUP button
Press this to display the system setup menu.
CURSOR buttons
Use these to move the cursors the left, right, up and down on
the screen
ENTER button
Press this to switch the display.
Also use this button to complete the setting.
SURROUND BACK
All Channel and Frequency=0dB
Front Sp. Center Sp.
Large Small
Front L & R Center
12 ft (3.6 m) 12 ft (3.6 m)
Front R Center
Front L
0 dB 0 dB 0 dB
(Remote control unit)
Default settings
All
OFF
Mic
Default settings
Subwoofer Surround Sp. Surround Back Sp.
Yes Small Small / 2spkrs
Subwoofer Surround L & R
12 ft (3.6 m) 10 ft (3.0 m)
Surround Surround Surround Surround
L R Back L Back R
0 dB 0 dB 0 dB 0 dB
80Hz
LFE
SBL & SBR
10 ft (3.0 m)
Subwoofer
0 dB