Speaker Setup; Setting The Speaker Configuration - Denon AVR-887 Operating Instructions Manual

Denon operating instructions av surround receiver avr-887
Hide thumbs Also See for AVR-887:
Table of Contents

Advertisement

ENTER
D H F G
ENTER
D H F G
[TEST TONE]
About the button names in this explanation
<
>
: Buttons on the main unit
[
]
: Buttons on the remote control unit
Button name only :
Buttons on the main unit and remote control unit
Advanced Setup – Part 2
F G, ENTER

Speaker Setup

• If the "Auto Setup" procedure has already been performed, there is
no need to make this setting.
• Perform this setting if you wish to make the settings for your
speaker systems manually.

Setting the Speaker Configuration

D H
Automatically set the output component and properties for the
various channels according to the combination of speakers to be
actually used for surround playback.
1
D D H H
Press
to select "Speaker Setup", then press
ENTER
.
2
D D H H
Press
to select "Speaker Config.", then press
ENTER
.
3
D D H H
Press
to select the speaker, then press
Large:
Select this when using large speakers with ample low frequency
reproduction capabilities.
Small:
Select this when using small speakers without ample low frequency
reproduction capabilities.
None:
Select this when no speaker is connected.
Yes / No:
Select "Yes" when a subwoofer is connected, "No" when no
subwoofer is connected.
2spkrs / 1spkr:
Select the number of surround back speakers.
4
1
F F G G
to set.
• Select "Large" or "Small" not according to the actual size of the speaker
but according to the speaker's capacity for playing low frequency
(bass sound below the frequency set for the Crossover Frequency)
signals. If you do not know, try comparing the sound at both settings
(setting the volume to a level low enough so as not to damage the
speakers) to determine the proper setting.
60
ENGLISH
A subwoofer with sufficient low frequency playback capability can
better handle deep bass than most main and surround speakers,
and the system's overall performance will be greatly enhanced
when "Small" is set for the main (front) and surround speakers.
When "Front" is set to "Small", "Subwoofer" is automatically set
to "Yes", and when "Subwoofer" is set to "No", "Front" is
automatically set to "Large".
ENTER
Press
.
2
3
h h
Center speaker
Front speaker
Subwoofer
Surround speaker
Surround back speaker
ENGLISH

Advertisement

Table of Contents
loading

Table of Contents