Starting Auto Setup; Checking And Storing The Measurement Results - Denon AVR-887 Operating Instructions Manual

Easy Setup Procedure
y Starting Auto Setup
D D H H
Press to select "Start", then press
• Start the measurements.
Measurement of each channel is performed as follows:
1
FL FR C SW SL
1: The subwoofer speaker is measured twice.
2: Not displayed when "ZONE2" and "Front" are set at "Setting the
Power Amplifier Assignment" ( page 58).
• After each channel is measured, "Calculating" appears.
• The display switches to the Auto Setup check screen
automatically.
e e
NOTE:
• Do not change the speaker connections or subwoofer volume
after making the measurements.
• Do not turn off the power while the data is being stored.
Cautions during measurements:
• Loud test tones are output during the measurements. Be careful
for example when small children are nearby.
F F
.
• Proper measurements may not be possible if there are obstacles
between the speaker and the setup microphone.
• During the measurements, do not stand between or near the
speakers and setup microphone.
2
• To avoid influencing the measurements, turn off the power of air-
SR SBL SBR
conditioners or any other equipment producing sound in the
room. Perform the measurements with the room as quiet as
possible.
• Measurement is cancelled when VOLUME is operated while the
Auto Setup is performed.
¢ About automatic retry
To confirm the results of the measurements, remeasurement is
automatically performed.
Remeasurement is performed up to two times. During this time,
"Retry1" or "Retry2" is displayed on the screen.
u Checking and storing the measurement
1
2
Store:
Retry:
Cancel:
3
• When measurements have been made using the measurement
microphone, speakers with a built-in filter such as subwoofers might
be set with a value that differs from the physical distance because
of the internal electrical delay.
12
ENGLISH
Easy Setup Procedure
results
D D H H
Press to select an item, then press
The measurement results of each item can be checked here.
ENTER
After checking, press , then press
All the settings are stored in the memory.
Perform the measurement again.
Measurement is repeated.
Cancel the auto setup settings.
When "Store" is selected:
F F
Press .
1
h h
(Press ENTER.)
2
Example: Speaker Configuration Check
ENGLISH
ENTER
.
D D H H
to set.