System Setup Items And Default Values - Denon AVR-886 Operating Instructions Manual

Advanced Setup – Part 2
System setup items and default values (set upon shipment from the factory)
1. Auto Setup / Room EQ
Auto Setup / Room EQ
Set this to switch the surround back
Power Amp
1 Auto Setup channel's power amplifier for ZONE2 or Bi-
Assign.
Amp use .
Manual EQ This parameter is for optimizing the Room EQ with which
2
Setup the audio signals are produced from the speakers.
Room EQ Set the Room EQ setting with "All" or "Assign" for each
3
Setup surround mode.
Direct Mode Set the ON/OFF setting of Room EQ, in the case of the
4
Setup surround mode is in "Direct" or "Pure Direct".
2. Speaker Setup
Speaker Setup
Input the combination of speakers in your system and their
corresponding sizes (SMALL for regular speakers, LARGE
Speaker
1 for full-size, full-range) to automatically set the composition
Config.
of the signals output from the speakers and the frequency
response.
This parameter is for optimizing the timing with which the
2 Delay Time audio signals are produced from the speakers and
subwoofer according to the listening position.
This adjusts the volume of the signals output from the
Channel
3 speakers and subwoofer for the different channels in order
Level
to obtain optimum effects.
Crossover Sets the frequency (Hz) below which the bass sound of
4
Frequency the various speaker is to be output from the subwoofer.
SW Mode This selects the subwoofer speaker for playing deep bass
5
Setup signals.
Default setting
SURROUND BACK
All Channel and Frequency = 0 dB
All
OFF
Default setting
Front Sp. Center Sp. Subwoofer Surround Sp.
Large Small Yes Small
Front Surround
Center Subwoofer
L & R L & R
12 ft 12 ft 12 ft
Front Front Surround
Center Surround L Surround R
L R Back L
0 dB 0 dB 0 dB 0 dB 0 dB 0 dB
80 Hz
LFE (Normal)
52
ENGLISH
Page
8~11
50
50, 51
51
Page
Surround Back
Sp.
46
Small / 2sp
Surround Back
L & R
47
10 ft 10 ft
Surround
Subwoofer
Back R
47, 48
0 dB 0 dB
48
49
ENGLISH
Advanced Setup – Part 2