Searching Categories; Ipod ® Playback; Basic Operation - Denon AVR-588 Owner's Manual

ENGLISH
<SOURCE SELECT>
<ON/STANDBY>
[Front]
[1]
[6], [7]
[8], [9]
uiop
[MODE
SELECTOR 1]
[Rear]
[MODE]
uiop
About the button names in these explanations
< > : Buttons on the main unit
[ ] : Buttons on the remote control unit
Button name only:
Buttons on the main unit and remote control unit
 

Searching Categories

STATUS
ui
1
Press o p
C A T :
2
o p
Use to select the category, then use
the desired station.
op
• "LOADING" is displayed while stations or data are being received.
• "UPDATING" is displayed while the encording code is being
updated.
• "XM – – –" is displayed if the selected channel cannot be used.
[CHANNEL +/–]
iPod ® Playback
[2]
The music on an iPod can be played by using the Control Dock for
iPod (ASD-1R, sold separately).
The operation can also be performed using the buttons on the
remote control unit.
iPod is a trademark of Apple Inc., registered in the U.S.
and other countries.
[ENTER]
b The iPod may only be used to copy or play contents that are not
STATUS copyrighted or contents for which copying or playback is legally
permitted for your private use as an individual. Be sure to comply
with applicable copyright legislation.
[MODE
SELECTOR 2]
[iPod]
[ENTER]
.
Channel category
R o c k
ui
to select

Basic Operation

1
Make the necessary preparations.
q S et the iPod in the DENON Control Dock for iPod.
(vSee the Control Dock for iPod's operating instructions.)
w Assign the Control Dock for iPod's input.
"System Setup" – "Input Setup" – "iPod Assign"
(vpage 23)
2
<SOURCE SELECT>
Either turn
select the input source assigned in step 1-w above.
R e m o t e i P o d
b
If the displays above are not displayed, the iPod may not be
properly connected. Try connecting again.
3
[MODE SELECTOR 1]
Set to "AUDIO" and
SELECTOR 2]
to "iPod/NETWORK".
(vpage 39 "Remote Control Unit Operations")
• With the default settings, the iPod can be used connected to the VCR
(iPod) connector.
• Use the RESTORER mode to expand the low and high frequency
components of compressed audio fi les and achieve a richer sound.
The default setting is "Mode3" (vpage 29).
• Press <ON/STANDBY> and set the AVR-588's power to the standby
mode before disconnecting the iPod. Also switch the input source to
one to which "iPod Assign" is not assigned before disconnecting the
iPod.
NOTE
• Depending on the type of iPod and the software version, some
functions may not operate.
• DENON will accept no responsibility whatsoever for any loss of iPod
data.
[iPod]
or press to
[MODE