Denon AVR-588 Owner's Manual page 56

ENGLISH
GAudioH
Symptom Cause
No sound is • You are playing a monaural
produced from source (TV, AM radio broadcast,
center speaker. etc.) in the "STANDARD" (Dolby/
DTS Surround) mode.
No sound • The surround mode is set to
is produced "STEREO" or "DIRECT" .
from surround
speakers.
No sound is • The surround back speaker's
produced from power amplifier is assigned to a
surround back different channel.
speaker. • Surround back speaker setting is
set to "None" .
• Surround mode not set to a mode
for 6.1- or 7 .1-channel playback.
No sound is • Subwoofer's power not turned
produced from on.
subwoofer. • The "Subwoofer" setting at
"Speaker Setup" is set to "No" .
• The subwoofer is not properly
connected.
• The subwoofer's
turned off.
No test tones are • Surround mode not set to
produced when "STANDARD"
remote control Surround).
unit's TEST button
is pressed.
DTS sound is not • DVD player's audio output setting
output. is not set to bitstream.
• DVD player is not compatible
with DTS sound playback.
• The AVR-588's "Input Mode"
setting is set to other than
"DTS" .
HDMI audio
signals are not
output from
–
speakers.
No sound is • HDMI input setting is improper.
output from
the monitor
connected
with HDMI
connections.

Countermeasure
• The mode is set to something
other than "STANDARD" (Dolby/
DTS Surround).
• Set to a surround playback
mode.
• Check the setting and change it
as necessary.
• Set to something other than
"None" .
• Select a surround playback
mode.
• Turn on the subwoofer's power.
• Set to "Yes" .
• Check the connections.
volume is • Adjust the subwoofer's volume
to an appropriate level.
• Set to the "STANDARD" (Dolby/
(Dolby/DTS DTS Surround) mode.
• Set the DVD player. For details,
refer to the DVD player's
operating instructions.
• Use a DTS-compatible player.
• Set to the "Auto" or "DTS"
mode.
• The audio signal input to the
HDMI input connector cannot be
played on the AVR-588. Input the
audio signal to the digital audio
input connector or analog audio
input connector.
• Check the HDMI input setting.
GVideoH
Page Symptom
26 No picture • The connections between the
appears. AVR-588 and monitor are faulty.
• The monitor's input setting is
wrong.
• The player is connected using the
26
component input connectors, the
monitor is connected using the
video (yellow) or S-Video output
connectors.
24
No picture • The connections to the HDMI
appears connectors are faulty.
with HDMI • HDMI input setting is improper.
20
connections. • The HDMI format of the player
and monitor do not match.
25, 26
DVDs cannot be
copied on a VCR.
–
20
9
37
26
–
–
31
10
22
Cause Countermeasure
• Check the connections.
• Set properly.
• High definition (1080i/720p) and
progressive (480p/576p) video
signals are not down-converted.
Set the player to
(480i/576i) signals.
• Check the connections.
• Check the HDMI input setting.
• Match the HDMI format of the
player and monitor.
• This is not a malfunction. Most
movie software includes copy
–
prevention signals and cannot be
copied.
Page
10 ~ 17
–
–
interlace
10
22
10
–