Table of Contents
Advertisement
Introduction
Battery Installation
1.4
Four AAA-sized batteries are included in your meter's packaging:
1. Use a Philips screwdriver to remove the two screws holding the
battery cover. See Figure 4 : Battery Installation.
2. Remove the battery cover.
3. Insert the batteries. Follow the diagram inside the cover for correct
polarity.
4. Replace the battery cover onto its original position using the two
screws removed earlier.
5. The meter is now ready to operate.
Battery cover
NOTE: Dispose used batteries in accordance with your local regulations.
Philips Screws
Four 'AAA'-sized batteries
Figure 4 : Battery Installation
5
C401/301/201/102/101
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the WATERPROOF C401 COLORIMETER and is the answer not in the manual?