Table of Contents
Advertisement
ENGLISH
6
7
8
9
ENTER
*
To cancel the settings, select "Level Clear" and "Yes" on the "Channel Level" screen, then make the settings again.
The level of each channel should be adjusted to 75 dB (C-weighted, slow meter mode) on a sound level meter at the listening position.
If a sound level meter is not available adjust the channels by ear so the sound levels are the same. Because adjusting the subwoofer level test
tone by ear is difficult, use a well known music selection and adjust for natural balance.
NOTE:
When adjusting the level of an active subwoofer system, you may also need to adjust the subwoofer's own volume control.
*
When you adjust the channel levels while in the SYSTEM SETUP CHANNEL LEVEL mode, the channel level adjustments made will affect
ALL surround modes. Consider this mode a Master Channel Level adjustment mode.
*
After you have completed the SYSTEM SETUP CHANNEL LEVEL adjustments, you can then activate the individual surround modes and
adjust channel levels that will be remembered for each of those modes. Then, whenever you activate a particular surround sound mode, your
preferred channel level adjustments for just that mode will be recalled. Check the instructions for adjusting channel levels within each
surround mode on Page 44.
You can adjust the channel levels for each of the following surround modes: DIRECT, STEREO, 5 CH STEREO, DOLBY/DTS SURROUND,
*
ROCK ARENA, JAZZ CLUB, VIDEO GAME, MONO MOVIE, and MATRIX.
When using either surround speakers A or B, or when using surround speakers A and B at the same time, be sure to adjust the balance of
*
playback levels between each channel for the various selections of "A or B" and "A and B".
24
Select "Test Tone Start".
Select "Yes".
a. If the "Auto" mode is selected:
Test tones are automatically emitted from the different speakers.
The test tones are emitted from the different speakers in the following
order, at 4-second intervals the first time and second time around, 2-
second intervals the third time around and on:
FL
C
FR
1
1
1
Use the CURSOR buttons to adjust all the speakers to the same
volume.
The volume can be adjusted between –12 dB and +12 dB in units of 1
dB.
b. When the "Manual" mode is selected
Use the
and
cursor buttons to select the speaker from which you
want to produce the test tone, then use the
to adjust so that the volume from the different speakers sounds the
same.
After the above settings are completed, press the ENTER button again.
The "Channel Level" screen reappears.
SR
SL
SW
1
1
1
Flashing
and
cursor buttons
Example: When the volume is set to –12 dB
while the test tone is being
produced from the subwoofer
Flashing
Example: When the volume is set to –12 dB
while the subwoofer is selected
Hide quick links:
Advertisement
Table of Contents
