Thermo Scientific ALPHA PH 550 Manual page 33

1
SETUP
ENT
From pH (or ORP) measurement mode press ENT key to enter
1 1
setup mode as described in section 5.1. The LCD shows the first
screen of setup mode (OFS). Press ▲ or ▼ key to select
configuration settings screen (Cnfg).
Press ENT key to access configuration settings (Cnfg).
Select measurement mode: The upper display shows the last
2
configured measurement mode ('PH' or 'OrP').
Press ▲ or ▼ key to select your desired measurement mode.
Press ENT key to confirm your selection.
NOTE: When the measurement mode is changed, the relay
operation parameters (described in section Error! Reference
source not found.) will be reset back to their default values.
Select operation mode: The upper display shows the last
3
configured operation mode. ('ASY' or 'SY').
Press ▲ or ▼ key to select your desired operational mode.
Press ENT key to confirm your selection.
Reset to factory defaults: The display shows 'nO dEF'.
4
Press ▲ or ▼ key to select:
nO dEF :
FCt dEF:
2
SETUP
ENT
2
SETUP
ENT
No default reset of the pH Monitor. User configured
values remain active, when confirmed by pressing
ENT key.
Reset all settings of the pH Monitor to factory
defaults, when confirmed by pressing ENT key.
3
SETUP
3
SETUP
- 29 -
4
SETUP
ENT
4
SETUP
ENT
4
SETUP
MEAS
pH
READY
°C
ATC
ENT
ENT