For Canadian Modem Users - 3Com 000839-08 Manual

For Canadian Modem Users

NOTICE: The Industry Canada (IC) label
identifies certified equipment. This certification
means the equipment meets certain
telecommunications network protective,
operational, and safety
requirements as prescribed in the appropriate
Terminal Equipment Technical Requirements
document(s). The Department does not
guarantee the equipment will operate to the
user's satisfaction.
Before installing this equipment, users should
ensure that it is permissible to be connected to
the facilities of the local telecommunications
company. The equipment must also be
installed using an acceptable method of
connection. In some cases, the company's
inside wiring associated with a single-line,
individual service may be extended by means
178
R I
EGULATORY NFORMATION
of a certified connector assembly (telephone
extension cord.) The customer should be
aware that compliance with the above
conditions may not prevent degradation of
service in some situations. Currently,
telecommunication companies do not allow
users to connect their equipment to jacks
except in precise situations that are spelled out
in tariffing arrangements with those companies.
Repairs to certified equipment should be
coordinated by a representative designated by
the supplier. Any repairs or alterations made
by the user to this equipment, or equipment
malfunctions, may give the telecommunications
company cause to request the user to
disconnect the equipment.
For your own protection, make sure that the
electrical ground connections of the power
utility, telephone lines, and internal metallic