Toyota TUNDRA-2005 Owner's Manual page 313

B
(b) Operating the HomeLink
B
To operate the HomeLink , press the
B
appropriate HomeLink button to activate
the programmed device. The HomeLink
indicator light should come on.
B
HomeLink continues to send the signal
for up to 20 seconds as long as the
button is pressed.
(c) Erasing the entire HomeLink
memory (all three programs)
To erase all previously programmed codes
at one time, press and hold down the 2
outside buttons for 20 seconds until the
indicator light flashes.
If you sell your vehicle, be sure to erase
the programs stored in the HomeLink
memory.
312
'05 TUNDRA_U (L/O 0409)
CAUTION
A
When programming the HomeLink
B
Universal Transceiver, you may be
The
operating a garage door or other
device. Make sure people and ob-
jects are out of the way of the ga-
rage door or other device to pre-
B
vent potential harm or damage.
A
Do not use this HomeLink
sal Transceiver with
door opener that lacks the safety
stop and reverse feature as re-
quired by federal safety standards.
(This includes any
B
opener model manufactured before
April 1, 1982.) A garage door open-
er which cannot detect an object
(signaling the door to stop and re-
verse), does not meet current feder-
al safety standards. Using a garage
door opener without these features
increases risk of serious injury or
death.
This device complies with Part 15 of the
FCC Rules and with RSS- 210 of the IC
B
Rules. Operation is subject to the fol-
lowing two conditions: (1) This device
may not cause harmful interference, and
(2) this device must accept any interfer-
ence received,
that may cause undersired operation.
WARNING: This transmitter has been
B
Univer- tested and complies with FCC and IC
any garage rules. Changes or modifications not
expressly approved by the party re-
sponsible for compliance could void
the user's authority to operate the
garage door device.
2005 TUNDRA from Sep. '04 Prod. (OM34432U)
including interference