Auto Adjustment; Setting Picture Format; Manual Configure - LG 50PM1M - - 50" Plasma Panel Owner's Manual

U514Aen 81/11/9 2:28 PH Page 26
Screen Adjustment
@ Screen Adju
merit
- RGB (PC) mode only; This function doesn't work for RGB (DTV) mode.
- Automatically adjusts picture position and minimizes image shaking.
- After adjustment, if the image is still not correct, your set is functioning properly but needs further adjustment.
- The Auto con|ig, and Manual con|ig, are not active in HDMI mode.
1. Press the MENU button and then use _, / T button to select the SCREEN menu.
2. Press the 1_button and then use h, / _" button to select Auto con|ig..
3. Press the _ button to run Auto configure.
* When Auto config, has finished, OK will be seen on the screen.
* If the position of the image is still not correct, try Auto adjustment again.
4. In RGB (PC) mode, if the image needs to be adjusted more after using Auto
conflg., you can make further adjustments with the Manua] con|ig, option.
Caution: If a 4:3 fixed image is on the screen for a long time, it may remain visible.
Set every aspect ratio for Video, Component 480i sources.
Use 4:3 or 16:9 for other RGB(PC), HDMI(PC) sources.
Horizon is not available for RGB (DTV), HDMI (DTV), and Component (DTV) sources.
Press the ARC button repeatedly to select the desired picture format. You can also adjust ARC in the SCREEN menu.
* 4;3
Choose 4=3when you want to view a picture with an original 4:3 aspect ratio, with black bars appearing at both the left and right sides.
* 16,9
Choose 16:9 when you want to adjust the picture horizontally, in a linear proportion to fill the entire screen.
* Ho='i_'on
Choose Horizon when you want to adjust the picture in a non-linear proportion, that is, more enlarged at both sides, to create
a spectacular view.
* 7.0 On1
- Choose Zoom when you want to view the picture without any alteration. However, the top and bottom portions of the picture will be cropped.
1,
2.
3.
If the image still isn't clear after auto adjustment and especially if characters are still jittery, adjust the picture Phase
manually.
To correct the screen size, adjust Clock.
Phase, Clock, H-position, V-position function works in the following mode : RGB-PC.
Only H-position, V-position function works in the following mode :RGB-DTV, COMPONENT (480p, 720p,1080i), HDMI-
DTV (480p, 720p,1080i) mode.
Press the MENU button and then use A / T button to select the $CRV-EN menu.
Press the _" button and then use A / _" button to select Manua! ¢oafig..
Press the I_ button and then use _, / _" button to to select Phase, Clock,
H-Position or V-Position.
4. Use the ,,t/1_ button to make appropriate adjustments.
* The Phase adjustment range is 0 - 63.
* The Clock adjustment range is -20 - +50.
5. Press the ENTER button to save.
26 Plasma Monitor