Honeywell HW5500E - Portable Generator NOT Owner's Manual page 13

Step 1: Install Support Legs
To install support legs, you will need:
‰ M8 x 30 mm long hex flange bolts (2)
‰ M8 x 16 mm OD x 1.5 mm washers (2)
‰ M8 serrated flange nuts (6)
‰ M8 x 16 mm long full-thread hex flange bolts (4)
‰ Brackets (2)
‰ Rubber stoppers (2)
‰ Socket wrench with 13 mm socket
* Not included
Generator must be empty of engine oil and fuel.
Drain engine oil and fuel, if necessary.
Generator is heavy! Lifting generator can cause
back or other bodily injury. NEVER lift generator
without assistance.
Place the generator on a flat, level surface.
1.
2. Stand at side of generator opposite recoil starter
handle. Grip frame; carefully pull up and push to tilt
generator backward.
FIGURE 5: Tip onto Generator Recoil Side
Gently set generator onto the recoil side or elevate
3.
the generator by placing solid wood pieces under-
neath unit.
4. Place a washer in the center of each rubber stopper.
HW5500/HW5500E/HW5500EL/HW5500L Portable Electrical Generator Owner's Manual
5.
*
6.
Attach a rubber stopper to the bottom of each support
leg using a 30 mm long hex flange bolt and a serrated
flange nut; tighten until securely seated.
FIGURE 6: Rubber Stopper Attached to Support Leg
Attach each support leg to pre-drilled holes on bottom
of generator frame, using 16 mm long full-thread hex
flange bolts and serrated flange nuts; tighten until
securely seated.
FIGURE 7: Support Leg Attached to Generator
www.honeywellgenerators.com
Assembly
7