Connections - Denon DN-X1500 Operating Instructions Manual

ENGLISH
4

CONNECTIONS

Refer to the connection diagram below.
1. Make certain AC power is off while making
connections.
2. Quality cables make a big difference in fidelity and
punch. Use high-quality, audio cables.
3. Do not use excessively long cables. Be sure plugs
and jacks are securely fastened. Loose connections
cause hum, noise, or intermittents that could
damage your speakers.
4. Connect all stereo input sources. Then connect any
effects into the stereo effect, if used. Connect your
microphone(s) and monitor headphones. Make sure
all faders are at "zero" and the unit is off. Take care
to connect only one cable at a time. pay attention to
L and R position of jacks, on both the DN-X1500 and
outboard gear.
5. Connect the stereo outputs to the power
amplifier(s) and/or tape deck(s) and/or MD
recorder(s) and/or CD recorder(s). Plug the DN-
X1500 into AC power outlet.
Main balanced power amplifier
Main unbalanced power amplifier
Booth unbalanced power amplifier
Tape deck
8
NOTE:
Always switch on your audio input sources such as
CD players first, then your mixer, and finally any
amplifiers. When turning off, always reverse this
operation by turning off amplifiers, then your mixer,
and then input units.
CD player
R L
L R
CD recorder or PC
CD player
Turntable 3 Turntable 2
KEY ADJUST PITCH
-12
BRAKE SLOW BRAKE SLOW
Quartz 0
OFF ON OFF ON
POWER POWER
+12
START START
/STOP 78 /STOP 78
33 45 DP-DJ151 Digital 33 45
R L L R R L
L R
L R R L
R L R
MD recorder
Turntable 1 Balanced microphones
KEY ADJUST PITCH KEY ADJUST PITCH
-12 -12
BRAKE SLOW
Quartz 0 Quartz 0
OFF ON
POWER
+12 +12
START
/STOP 78
DP-DJ151 Digital 33 45 DP-DJ151 Digital
L R L R
L
Effects processor