Lexicon PCM 91 - REV 1 User Manual page 53

PCM 91
The Patch Row
Each PCM 91 effect has an identical Patch row in its Edit matrix
where you can make as many as 10 patches.
Patches
Patch 0 Patch 1
Patch 5 Patch 6
To make a patch, use SELECT and the Down button to move down
through the Edit matrix to the Patch row. A display such as the
following will appear.
The asterisk ( ✱ ) indicates that Sources will be selected when you turn ADJUST.
Press Load/✱ to change the selection to Dst. Press Load/✱ again to bring up
the Values display where you can select Src Value and Dst Value.
SELECT will move
you across the
Patch Row (0-9).
The Source type is indicated here. (Int, MIDI or 001-119
to indicate a MIDI Controller.)
Pressing the Load /✱ button will change the display to allow you
to sequentially select: Src, Dst, Src Value and Dst Value. Press Up or
Down together with Load /✱
parameter.
Assigning a Source
Three types of sources are available: Internal, MIDI and MIDI
Controller. These types are indicated in the Source list by the labels:
Int, MIDI, or a number (001-119). Turn ADJUST to scroll through
the entire list of available sources.
Patch 2 Patch 3 Patch 4
Patch 7 Patch 8 Patch 9
The current Source
✱
assignment name
is shown here. (The
default assignment
is Int . . . Off.
to backstep to the previous
Assigning a Destination
Once you have selected a Source, press Load /✱ and the display
will change to allow you to assign a Destination (Dst).
The asterisk ( ✱ ) indicates that Destinations will be selected when you turn
ADJUST. Press Load/✱ to bring up the Values display where you can assign
Src Value and Dst Value. Press Load/✱ again to return to Source selection, etc.
SELECT will move
you across the
Patch Row (0-9).
The Edit matrix row label
for the currently assigned
parameter is shown here.
Turn ADJUST to scroll through all of the parameters in the Edit
matrix of the currently loaded effect, including the Modulation
parameters.
Once you have assigned a parameter as a Destination, the
controller you have assigned "owns" that parameter. Adjustments
made to this parameter from the Edit matrix, will only affect the
initial value of the parameter when the program is loaded.
The behavior of the parameter on program load is determined by
the setting of the Patch Update parameter in Control mode (1.7).
This parameter can be set to Immediate or Delayed.
Basic Operation
✱
The name of the current Destination
assignment appears here. (*** Unassigned***
will appear across the bottom display line if no
assignment is selected.)
. . . continued on page 2-32
2-31