Lexicon PCM 91 - REV 1 User Manual page 127

Presets
PROGRAM BANK 4: SPLITS
CUSTOM
(continued)
4.1 Ring Verb
KeyWords: Splits, Special FX, Spatial, Custom
This Chamber/Hall preset lets you have a long, bright reverb and
an ultra-metallic ring mod. ADJUST lets you blend or separate these
two effects. Custom 1 tunes the frequency of the ring mod.
Custom 2 lets you change the In Routing status. Enhance your
stereo sound with Custom 3, or use Custom 4 to turn up some
delay and then Tap in the delay time or dial in the BPM.
• Custom 1: Mod Tuner
• Custom 2: In Routing
• Custom 3: Stereo Enhancer
• Custom 4: TapReflect Level
4.2 Dark & Brite
KeyWords: Splits, Special FX, Spatial, Custom
A dark, dense reverb and a bright, thin reverb. Use ADJUST to
balance the two. Use the Inverse EQ effect on Custom 1 to cut the
highs on the Room while boosting them on the Chamber. Custom
2 lets you change the effect from forwards to backwards, while
Custom 3 adds a bit of Predelay to the signal. Custom 4 gives you
a bit more EQ enhancement.
• Custom 1: Inverse EQ
• Custom 2: Inverse Effects
• Custom 3: Pre Delay
• Custom 4: Briteness Enhancer
4-30
(continued)
ADJUST: Verb to Mod
ADJUST: Reverb Blend
4.3 Dark & Gated
KeyWords: Splits, Special FX, Custom, Gated
A dynamic effect with input level affecting the Shape setting of the
Room, and triggering the Infinite switch on the Chamber reverb.
When Infinite triggers, then releases, a gate effect is produced. Use
ADJUST to change the Mode of the AR envelope. Use Custom 1 to
change the release time of the gate. Custom 2 changes the balance
of the Chamber/Room levels, Custom 3 changes their Sizes. Input
level also controls a Master Delay line that is active at lower levels,
then cuts out and the gate kicks in at higher levels. Use Custom 4
to change the level of this delay.
• Custom 1: Gate/Shape Release
• Custom 2: Effects Blend
• Custom 3: Switch the Sizes
• Custom 4: Master Delay Level
4.4 Pipe Reverb
KeyWords: Splits, Special FX, Bright, Custom
With the characteristics of a pipe in mind, this small drain to enor-
mous tunnel reverb is a great special effect for television or film.
Use ADJUST to choose pipe size, or Custom 1 to control basic Size
settings. Use Custom 2 to change high-frequencies for more EQ
control.
• Custom 1: Size
• Custom 2: High Cut
Lexicon
ADJUST: Toggle Gate FX
ADJUST: PipeSize