Setup Windows Audio And Midi; Using Cubase Le With The Lexicon Omega Studio - Lexicon OMEGA STUDIO Software Installation Manual

C. SETUP WINDOWS AUDIO AND MIDI
When the Lexicon USB Audio and MIDI drivers were installed, Windows may have automatically selected
them as your default audio and MIDI outputs. This means that your Windows sounds will be sent to the
Omega rather than your computer's sound card. We need to check if these have been changed and
return the settings to what they were before.
1. Select Start>Control Panel>Sound and Audio Devices.
2. Select the Audio tab.
3. Under Sound Playback>Default device, open the pull-down menu and make sure your
computer's sound card is selected.
4. Under Sound Recording>Default device, open the pull-down menu and make sure your
computer's sound card is selected.
5. Under MIDI Music Playback>Default device, open the pull-down menu and make sure your
MIDI device is selected.
D. USING CUBASE LE WITH THE LEXICON OMEGA STUDIO
1. Start Cubase LE. The first time you use Cubase LE with the Lexicon Omega Studio your may be
asked to run the Multimedia test as shown below. Select No.
2. Cubase LE will display the following warning that configuration has not been tested. Click OK.