Lexicon OMEGA - ANNEXE 723 Owner's Manual page 21

OMEGA
™
1. Plug one microphone into each of the two microphone jacks on the back of the
Omega. Plug the line output of the keyboard into the Line In 4 jack on the back of the
Omega. Plug the guitar into the Instrument jack on the front of the Omega Studio
2. Now we need to assign the USB streams to the inputs. Press the
Mic 1 and Mic 2 until the red 1-2 LED is lit. Next, press the
3 and Line 4 until the green 3-4 LED is lit.
USB Assign Button 1-2
3. Open Cubase ® LE 4, go to
inputs of thetracks in Cubase LE 4 so we can record from the four different inputs
of the Omega, each onto its own separate track. Click the Devices menu and select
VST Connections. The VST Connections dialog appears. Click the Add Bus button,
then click OK. Close the VST Connections dialog. To add an audio track, right
click in the dark gray column and select Add Audio Track. In the Add Audio Track
dialog, set the configuration to Mono and click OK. Click on the
box and select
IN STEREO IN > LEFT
RECORD ENABLE
button so that it is not lit. This track will record microphone 1. Add a second
track (right click in the gray area, select Add Audio Track). Click this track's
box and select
- STEREO IN
click on the
RECORD ENABLE
MONITORING
2. Add a third track. Click this track's
as the track input source. Next, click on the
IN 2 > LEFT
button so that it is red. Click on the
is not lit. This track will now record the guitar. Add a fourth track and click its
box and select
LEFT - STEREO IN
Next, click on the
RECORD ENABLE
MONITORING
(keyboard).
4. On the front of the Omega make sure the
button is in the
1-2
the microphone while gradually turning up the Mic 1 gain. It's
OK to see the peak light come on occasionally. Now check the
meter on the front of the Omega to make sure you are not clip-
Recording Multiple Channels At One Time - Section I
and start a new default project . Now let's set the
FILE
as the track input source. Next, click the
button so that it is red. Click on the
STEREO IN > RIGHT
button so that it is red. Click on the
button so that it is not lit. This track will record microphone
LEFT - STEREO IN
INPUT MONITORING
STEREO IN 2 > RIGHT
button so that it is red. Click on the
button so that it is not lit. This track will now record Line 4
position (button is out). Now speak into
USB ASSIGN
USB ASSIGN
USB Assign Button 3-4
LEFT - STEREO
INPUT MONITORING
as the track input source. Next,
box and select
RECORD ENABLE
button so that it
as the track input source.
METER ASSIGN
(Meter 1-2 and 3-4)
TM
.
between
between Line
LEFT
INPUT
STEREO
INPUT
21