Lexicon OMEGA - ANNEXE 723 Owner's Manual page 19

OMEGA
™
6. Now let's overdub a second track. Right
click in the dark gray column and select
. In the Add Audio Track dia-
AUDIO TRACK
log, set the configuration to Mono and click
. Under the Track Inspector select
OK
for track 2's input. Click on the
IN > LEFT
RECORD ENABLE
Click on the
INPUT MONITORING
1's
RECORD ENABLE
7. Now we will set our monitor levels so we
get a comfortable monitor mix level. On
the front of the Omega Studio
Knob. While playing back the
MONITOR MIX
previous recording listen to the input of the
microphone. To make the Microphone louder
than the recorded track, turn the
knob towards the
MIX
the recorded track louder turn the
knob towards the
MIX
This does not change the recorded volume, only what you hear while you are
NOTE:
recording. You can also adjust the playback level and pan position of the original track in
your monitor by adjusting the contols for Channel 1 on Cubase ® LE 4's Mixer window.
8. Now click on
RECORD
B. RECORDING A GUITAR INTO THE INSTRUMENT JACK
Now let's record a new basic track starting with a guitar
1. Plug your guitar into the instrument jack on the front of the
Omega Studio.
this jack is intended for passive guitar pickups, not line
NOTE:
inputs such as the output of a keyboard or a direct out from a
guitar amplifier. For those, use the Line In jacks on the back
of the Omega Studio.
2. The instrument jack uses Line 3, so press the
3 and 4 until the red 1-2 USB Assign LED is lit.
Press the
MONITOR
USB Assign Button
ADD
STEREO
button so that it is red.
button so that it is not lit. Click on Track
button so that it turns off.
TM
locate the
MONITOR
side. To make
DIRECT
MONITOR
side.
PLAYBACK
and record the second track.
button between line 3 and 4 so that it is in the
Recording A Microphone Input - Section 1
Input Louder
Output Softer
Monitor Mix
Instrument Jack
button between Line
USB ASSIGN
MONO
Monitor Button
Playback Louder
Input Softer
position.
19