Table of Contents
Advertisement
8. Now we are at the last page of the Setup Wizard, which is to configure
the WAN settings for SL6000/SL6300. Depending on the connection
mode required from your ISP, you may select from the following con-
nection modes from the Connection Mode drop-down list (see Figure
3.12): MPoA Bridged, PPPoE Relay, MPoA Routed, IPoA Routed,
PPPoA Routed and PPPoE Routed.
Figure 3.12 Setup Wizard WAN Configuration Page
Configuration Parameters
1. Channel: Select the ATM Interface that is to be configured or viewed
2. VPI and VCI: These settings are used to specify the Virtual Path Iden-
tifier (VPI) and Virtual Channel Identifier (VCI) that is used for con-
necting the Broadband Gateway to the ISP's ATM Switch using the
specified ATM Interface.
• VPI: Enter the VPI of the ATM Connection to the ISP's ATM Switch
• VCI: Enter the VCI of the ATM Connection to the ISP's ATM Switch
3. Select the option VC Mux to carry your Internet Service without en-
capsulation over the ATM Interface, else select the option LLC - con-
tact your ISP for details
ASUS VPN ADSL Router
Chapter 3
27
Advertisement
Table of Contents
