Table of Contents
Advertisement
Chapter 3
4. Default Gateway: Select this channel as default gateway of the Broad-
band Gateway
5. RIP Tx/Rx: Select send/accept routing updates on the channel via RIPv1
or RIPv2, this setting will only be effective if RIP is enabled in Global
Setting page
6. QoS: These settings are used to specify the service category and traffic
parameters that are to be applied for traffic over the specified ATM
interface. Choose one of the following options depending on your traf-
fic requirements.
•
None: The traffic carried over this interface will be on a best effort
basis without any guarantee of quality-of-service
•
CBR: The quality-of-service applied to traffic over this interface is
that applied to Constant-Bit-Rate (CBR) traffic.
•
VBR-rt: The quality-of-service applied to traffic over this interface
is that applied to Real-Time-Variable-Bit-Rate (VBR-rt) traffic.
•
VBR-nrt: The quality-of-service applied to traffic over this interface is
that applied to Non-Real-Time-Variable-Bit-Rate (VBR-nrt) traffic.
•
UBR: The quality-of-service applied to traffic over this interface is
that applied to Unspecified-Bit-Rate (UBR) traffic
ATM Service Configuration Parameters
a) MPoA Bridged and PPPoE Relay:
* No further configuration parameters need to be specified for MpoA
Bridged and PPPoE Relay services.
b) MPoA Routed:
* DHCP IP Address Assignment: Select this option if the MPoA Routed
Service interface is to obtain its IP address from your ISP via DHCP.
* Static IP Address Assignment: Select this option if the MPoA Routed
Service interface is to have its IP address configured statically.
* IP Address: Enter the MPoA Routed service interface's IP Address.
Contact your ISP for details
* Subnet Mask: Enter the MPoA Routed service interface's Subnet
Mask. Contact your ISP for details
c) IPoA Routed
28
ASUS VPN ADSL Router
Advertisement
Table of Contents
