Asus AM604 User Manual page 23

3. Set the WPA2 Preauthentication to Enabled if you want to use this function.
4. By default, the Network Re-auth Interval is 36000 seconds. Set up this value
based on your network environment.
5. To set up RADIUS server information, key in the WPA Group Rekey Interval,
RADIUS server IP address, RADIUS port, and RADIUS Key.
6. Set up the WPA encryption methods. If there are only WPA2 clients within your
network, select AES, if WPA clients only, select TKIP. If both exist, select TKIP+AES.
7. You can also enable WEP client to access your wireless network. To enable WEP
clients, set WEP Encryption to Enabled. Select 64-bit or 128-bit Encryption
Strength for key length then click Set Encryptioin Keys button to set up the keys.
Refer to Open mode Step 4 for key configuration.
8. Press Save/Apply to save and activate the settings.
WPA-PSK/WPA2-PSK
1. Click Wireless -> Security in the navigation menu to open the configuration page.
2. Select WPA-PSK/WPA2-PSK in the Network Authentication field.
3. Key in the WPA Pre-Shared Key. The key is masked by the system. To check the
key, press Save/Apply and wait until the page refreshes. Then click Click here to
display link, you can see the key displayed in a separate window.
4. Set up the WPA Group Rekey Interval.
5. Set up the WPA encryption methods. If there are only WPA2 clients within your
network, select AES, if WPA clients only, select TKIP. If both exist, select TKIP+AES.
6. You can also enable WEP client to access your wireless network. To enable WEP
clients, set WEP Encryption to Enabled. Select 64-bit or 128-bit Encryption
Strength for key length then click Set Encryption Keys button to set up the keys.
Refer to Open mode Step 4 for key configuration.
7. Press Save/Apply to save and activate the settings.
WL-AM604g 11g WiFi ADSL Router User Manual
xDSL LAN
4 3 2 1 !
AP LINK ACT
21