HP J3278B - SureStore CD-ROM Server/Tower 7 NAS Server Manual page 9

Documentation Notes
Configuring IP
for Novell
NetWare
Pure IP for Novell NetWare
In the User's Guide, the "Novell NetWare/IP" section near the
end of chapter 5 is replaced by this section.
In the Quick Installation Guide, item 4 under "Step 5. Set up
Novell NetWare (NCP)" should now refer to an additional page
("Protocols") that you should skip by clicking [Next > .
The HP CD/DVD-ROM Server now supports NCP transported over
pure IP. In Novell NetWare 5 environments, the server can be
integrated as any other 5.0 server, accessible using IPX,
NetWare/IP, and pure IP simultaneously. The compatibility mode
of NetWare 4.11 is no longer necessary.
Now, both IPX and pure IP are both enabled by default. NetWare/IP
remains as an option available for NetWare 4.11 environments.
Also, you can disable IPX and run NCP over IP only. See the
following section for these configuration options.
1. To use the IP protocol in NetWare, see Novell's documentation
to make sure that the NetWare TCP/IP environment is fully
implemented first.
2. Configure the server for IP, setting the following parameters.
Refer to the User's Guide or Quick Installation Guide.
• IP address (the following items must correspond to it)
• Subnet Mask
• Default Router (gateway)
• Primary DNS Server
• Secondary DNS Server
3. Configure the server for NetWare.
a. Select your protocol combination:
IPX Pure IP
enabled enabled
disabled enabled
enabled
disabled enabled
disabled
enabled
enabled
disabled
NetWare/IP Instructions
For NetWare 5.0. These default settings
disabled
already configured; no other step needed.
For NetWare 5.0. Before disabling IPX,
disabled
see Note below. Go to step b.
For NetWare 4.11. Go to step b.
(Before disabling IPX, see Note below.)
For NetWare 4.11 and 5.0. Go to step b.
enabled
(Before disabling IPX, see Note below.
Latest News: Firmware Version 5.30 9