3. From the Select a file server list, select the entry for your new
HP server. The default server name is HPhhhhhh_AT, where
hhhhhh are the last six digits of the server's MAC address. The
MAC address is displayed on the LAN Address label on top of the
tower. (The server name can be changed later during
configuration.) Click [OK].
If the AppleTalk protocol is not running on this Macintosh, then
the server will not be listed in the Select a file server list. In
this case, click [Server IP Address...], enter the IP address
assigned to the server, and click [Connect].
4. Select Registered User for administrative access. By default, the
user name is set to root and the password is set to pass. Enter
them and click [Connect].
5. Select the System folder and click [OK].
6. Open the System icon created on the desktop and open the
ServerProperties folder.
7. Open the config.ini file.
8. Go to the "[IP]" section and change the "InternetAddress"
setting shown to the IP address assigned to the HP server.
Latest News: Firmware Version 5.30
15