Installation - HP J3278B - SureStore CD-ROM Server/Tower 7 NAS Server User Manual

Installation

CAUTION!
CAUTION!
CAUTION!
SCSI connector
Verify that the power supply input voltage of the expansion
tower is set according to the power standards in the country
of use. If necessary, set the voltage switch on the rear of the
tower (see the illustration below) to 115 volts or 230 volts.
Verify that the power cable is correct for the country of use.
See page 2.
The SCSI bus of either the CD-ROM server or the expansion
tower may be damaged if you connect or disconnect the SCSI
cable when either unit is powered on.
1. Switch power to the CD-ROM server/tower off, or remove
power to the standalone server.
2. Place the expansion tower next to the CD-ROM server, as in
the example of the server/tower shown below.
Server/Tower
Expansion Tower
Input voltage switch
Power cord connector
SCSI connector
Second SCSI connector
Installation 3
2