Procedure - HP 345646-001 - StorageWorks NAS 2000s External Storage Server Installation Manual

Procedure

To initialize the NAS 2000s:
1. Connect the Ethernet cables to the respective network ports
of the NAS 2000s and the corresponding network segments.
See
network ports on the NAS 2000s.
2. Go to the NAS device and power it on. It will be several
minutes before the NAS device is accessible on the network.
Note:
has started.
3. Open Internet Explorer on the PC. Enter
serial number of the NAS 2000s followed by a hyphen (-),
and then
Example:
Note:
name was previously set.
4. Click Yes in the Security Alert dialog to accept the security
certificate.
5. Login to the WebUI. This launches the WebUI configuration
application (Rapid Startup) on the target HP StorageWorks
NAS device, as shown in
Note:
password is hpinvent. The WebUI uses the same login as the local
administrator's account or an account with administrative privileges.
6. Go to the next section
to complete the setup procedures.
NAS 2000s Installation Guide
Figure 3 and
The NAS device will respond when the NAS operating system
. Press Enter.
:3202
https://D4059ABC3433-:3202
Substitute the server name for the serial number if a server
The default login for the WebUI is administrator and the
Table 2 on page 14 for the locations of the
Figure
"Rapid Startup Wizard
https://
7.
Configuration,"
, the
25