Configuring The Software - Intel PRO1000 - MT Dual Port Server Adapter Quick Installation Manual

Ip storage adapter bringing gigabit ethernet to network storage

Table of Contents

Installing the Software in Linux

To install the software in RedHat* Linux Version 7.2 using the RPM

utility, follow these steps:

Locate the RPM package is1000-1.1-#.i386.rpm (# represents the

RPM version number) for a single or multiple processor host.

Install the package:

# rpm -i [...]/RedHat72/is1000-1.1-#.i386.rpm

RPM version number)

NOTE: The installation process will install support for a single and

multiple processor systems, but at boot-up, the SYS V script will

determine which kernel is booting and load the appropriate

module.

Configuring the Software

The Intel

PRO/1000 T IP Storage Adapter software can be used in a

Windows* (2000 or XP) or RedHat* Linux environment.

NOTE: If you already have one adapter installed and configured in your

system and you would like to install another adapter, remove all

the targets in PROSet before installing the new adapter.

Otherwise, PROSet indicates that both adapters are connected to

the same target and multiple connections to the same target can

occur.

NOTE: The Intel PRO/1000 T IP Storage Adapter allows you to connect to

a maximum of eight iSCSI targets at a time.

Linux

RedHat* Linux Version 7.2 configuration information is located in the

Readme.txt file in the RedHat72 directory on the Intel CD.

(# represents the

Table of Contents

Do you have a question about the PRO1000 - MT Dual Port Server Adapter and is the answer not in the manual?

Pro/1000 t