Lexicon DC-1 Owner's Manual page 22

Installation and
Calibration
16
Zone 2 Remote Control
The remote control can be placed into an exclusive Record/Zone 2 control
mode during normal operation by holding down ACCY while pressing
RECORD/ZONE 2. This will display the message:
In this mode, the Volume, Mute, Input selection and L/R Balance controls
will directly control the Zone 2 outputs with no effect on the Main outputs.
Pressing any other keys will display the message:
ZONE 2 MODE ENABLED
To exit Zone 2 Remote mode and return the remote control to normal
operation, press and hold ACCY while pressing SELECT. The message:
will be displayed to confirm that normal operation has been restored.
Exclusive Zone 2 Control
The DC-1 can also be used as an exclusive Zone 2 controller, allowing
remote use of the system while the local room(the room in which the
DC-1 is located) remains muted. To use the DC-1 in this manner, turn on the
DC-1 by pressing the RECORD/ZONE2 key on the remote. The unit will
power up with the System Mute and Effect Bypass activated. The remote
will default to Zone 2 IR Remote mode as described above, with Volume,
Mute, Input Selection and L/R Balance controlling only the Record and
Zone 2 outputs. To return to normal operation, simply press OFF, then ON.
Digital audio inputs can be selected for the Record/Zone 2 outputs
under the following conditions:
• The digital input must be assigned to an input via the Setup menu.
• The input must have Record/Zone 2 operation enabled. (TAPE and
VCR1 are normally "BLOCKED", but can be changed in the Setup
menu.)
• The input must be selected for Main outputs.
• Effect Bypass must be enabled.
ZONE 2 IR REMOTE
MODE ENABLED
KEY INVALID
NORMAL IR REMOTE
MODE ENABLED
Lexicon