Lubrication - Alamo Industrial FALCON 15/10 Operator's Manual

Before operating your Rotary Cutter, make sure it is properly lubricated and thoroughly inspected. Only a
minimum of time and effort is required to regularly lubricate and maintain this machine to provide long life and
trouble free operation.
Always disengage the PTO before raising the Rotary Cutter for transporting or making
adjustments.

Lubrication

Do not let excess grease collect on or around parts, particularly when operating in sandy areas. The
accompanying illustration shows lubrication points. The chart gives the frequency of lubrication in hours, based
on normal operating conditions. Severe or unusual conditions may require more frequent lubrication. FIGURE
MntP-R-0072.
Use an SAE multi-purpose, lithium-type grease for all locations shown. Be sure to clean the fitting thoroughly
before using grease gun.
Lubrication Fitting Location
ITEM DESCRIPTION
1 Spindle
2. Axle Turnbuckle
3. Tongue Pivot
4. Wheel Hubs
FALCON 15/10 03/09
© 2009 Alamo Group Inc.
MAINTENANCE
FREQUENCY
Weekly
8 Hours
8 Hours
Weekly
Maintenance Section 5-3