Function Key Operation - Yaesu PCC-2000 Reference Book

PCC-2000 R
You can program and assign the CAT commands into your computer's Function keys using the Vertex Standard KSE4PCC
Keyboard Shortcut Editor, then you may control the transceiver by pressing your computer's Function keys while activat-
ing the "PCC-2000" Personal Computer Controller.
Each of the following 46 Function keys may be programmed with a CAT command sequence. There are a total of 52
commands to chose from:
[ F2 ] key ~ [ F9 ] key, [ F11 ] key, [ F12 ] key,
[ Shift ] + [ F1 ] key ~ [ Shift ] + [ F9 ] key, [ Shift ] + [ F11 ] key, [ Shift ] + [ F12 ] key,
[ Cntl ] + [ F1 ] key ~ [ Cntl ] + [ F9 ] key, [ Cntl ] + [ F11 ] key, [ Cntl ] + [ F12 ] key,
[ Alt ] + [ F1 ] key ~ [ Alt ] + [ F3 ] key, [ Alt ] + [ F5 ] key, [ Alt ] + [ F7 ] key ~ [ Alt ] + [ F12 ] key,
[ Page Up ] key, [ Page Down ] key, [ Home ] key, and [ End ] key
Following is an example of programming a CAT command shortcut into one of the Function keys:
1. Copy the "KSE4PCC.exe" file into the folder where you in-
stalled the "PCC-2000.exe" file.
2. Double click the left mouse button on "KSE4PCC.exe" to
open the "Keyboard Shortcut Editor" pop-up window.
3. Enter the CAT command you wish to assin to a specific Func-
tion key.
Example 1: Set the VFO-A frequency to 14.250000 MHz.
FA14250000;
Example 2: Set the VFO-A Operating Mode to "USB".
MD02;
Example 3: Set the VFO-A frequecy to 14.250000 MHz,
USB mode.
FA14250000; MD02;
(Notice in Example 3 that you may assign more than one CAT
command to a single function key. Simply add a semi-colon
after each command, and end the command line with a semi-
colon).
Refer to the "FT-2000 CAT Operation Reference Book" for
the CAT command.
Note: You can not enter CAT commands into the following
function keys.
[ F1 ] key, [ F10 ] key, [ Shift ] + [ F10 ] key,
[ Cntl ] + [ F10 ] key, [ Alt ] + [ F4 ] key, and [ Alt ] + [ F6 ] key
4. You may append an Alpha-numeric "Tag" to a CAT Com-
mand for your reference (This is for reference only. The Al-
pha-numeric "Tag" is not displayed on the "PCC-2000" Per-
sonal Computer Controller).
To append a "Tag" to your CAT shortcut key, click the left
mouse button on the "Tag" or the "Both" parameter in the
"View" menu on the "Keyboard Shortcut Editor". Your new
reference "Tag" appears in the "Tag" column on the "Key-
board Short-cut Editor".
5. To close the "Keyboard Shortcut Editor" and save the CAT
commands, click "File" in the menu bar, and then click "Save"
in the drop-down list. In the Confirmation pop-up window,
click the [ Yes ] button to save the new setting.
EFERENCE
F K O
UNCTION EY
- 24 -
B
OOK
PERATION
"View" menu
"Tag" column "Tag" column